As much as I like my thin devices, all batteries should be user replaceable without the need for disassembly of any kind.
I mentioned this in another thread about the same thing. The Samsung Galaxy S3 was great for that. It was a 10 second job to pop off the back cover and swap out the battery. No risk of breaking the screen, no glue, no miniature cables to unplug and replug. That really should be the norm. It would be even better if we also didn’t have to buy expensive branded batteries to replace them.
It also had an official extended battery, which came along with a special backplate. It made the phone a bit bulkier, but I didn’t care. Battery went from 2100mah to 3000mah and it was great. I miss these types of accessories. I don’t care about glass back or waterproof phones.
Waterproofing _is_an important factor for sustainability for phones though. Water damage was THE cause of death of smartphones for a very long time until waterproofing became the standard for phones.
Yeah but you can have waterproofing AND swappable batteries
How? Currently, waterproofing works by slathering every crack and crevice in a sea of glue. Glue and easily replaceable batteries don’t mix.
The S5 had waterproofing with a removable back using gaskets. (Granted, the design was fugly, but that wasn’t the fault of the waterproofing measures. Someone at Samsung loved bandaids) If the S5 could do it, I suppose other manufacturers could achieve the same thing with rubber gaskets. I mean, other waterproof gadgets like dive computers use gaskets on their port covers and what not, so I fail to see why it wouldn’t work with battery compartments.
Huh, that could work pretty well! Gaskets would need to be secured and sealed well though, and I fail to imagine what an iPhone or any other modern device would look like with a removable battery lol.
This. My sister killed multiple phones per year until she went to phones with good waterproof ratings and subsequently were better sealed.
She hasn’t killed one since. That’s a lot less waste overall than before.
I’m not saying this is bad because of that, but I think it’s something people overlook.
My first iPhone was in my coat pocket at work. I picked up a bottle of beer that was juuuuust cracked enough that it would split around the middle from the slightest bump but not enough that the liquid would leak.
I stuck it under my arm to carry it and it split and spilled into my pocket. Not a lot made it in there but the phone never powered on again.
My Nextel back in the 90s had the same type of extended battery. Thick as hell by today’s standards but it didn’t actually fit better or worse in my pocket or my hand. Also didn’t feel like I needed an external case just because it might slip out of my hand at any second.
I loved my S3, I bought a few spare batteries for it with the battery wall charger, I’d just swap batteries instead of charging it
I’m ok with having standard screws holding it together. But no glue!
I’ll 100% prefer a thin but still repairable device that requires disassembly and common tools to replace the battery. Its not something that needs frequent changes any more, most devices can go 2 years plus and before the battery really needs changing, more if you take care of them.
For the Steamdeck it makes sense to have “old school” battery packs so people can choose. But for that same reason, it would be stupid to require by law for all devices to support hot swapping batteries.
Why not both?
If anyone had the sense to make a law forcing the modem processor and peripherals to be fully documented with all registers, protocols, API, architecture, and a reproducible toolchain for compiling the software, we might just have a sustainable future. Governments and large corporations already require this level of accountability for what they purchase and use. Anything less than this level of support and transparency is exploitive theft of ownership. Retaining any digital rights for any products sold is criminal theft.
Lol, as if any of those people have an idea of what these words even mean.
[This comment has been deleted by an automated system]
Sure they do. “This is theft. We don’t like theft. Stop theft by doing what we demand.”
I was referring to the first part of your post regarding the law enforcing doxumentation.
Sure they do. “This is theft. We don’t like theft. Stop theft by doing what we demand.”
Dear Citizen, we will require all manufacturers to comply with non-essential guidelines, but all important stuff are subject to the fact that you are our bitch and need to vow to your benefactor, the “government” which is Groupon for corpos.
Pretty sure some of the stuff he’s talking about are consumer issues too…fully documenting all the hardware lets people other than the original manufacturer provide support to the hardware without the use of reverse engineering.
Plus there’s a lot of non-essential stuff the government makes companies do already, because if they didn’t the companies would just exploit people. Food and Drugs being two big ones.
You realize 99% of legislators are tech illiterate boomers, right?
That’s why shits so fucked now, they are too old to be making laws for these things.
Politicians will always be generalists that must look to experts to advise them. The problem is there are few experts doing the advising and most are corporate funded with corporate agendas. Unless you are super into politics where these choices change your voting in a significant way, the situation will continue to suck.
The US used to have a panel of experts advising them, until it turned out they weren’t science deniers and the republicans claimed they were all “paid off by the libs!”
As long as tools to unclip the shell aren’t consider specialized, I think almost all existing handhelds are gonna meet the actual requirements here - they just have to be user replaceable, not use swappable, without the use of specialized tools or thermal energy. If you can unscrew it, disconnect the old battery and connect the new one, it complies. It’s really only an issue in waterproof devices, where they have to glue everything to seal it.
I read a lot of people claiming that waterproofing technology has come to a point where this isn’t too much of an issue, but that’s as far as my knowledge goes
It’s true. If you put a little gasket around the edges and make sure it’s held down tightly (clips, screws etc) it’s fine. Glue is cheaper and faster to manufacture, that’s why companies claim it’s necessary
deleted by creator
There are plenty of options for waterproofing removable batteries. They just tend to be large.
What’s the difference between swappable and replaceable
Swappable as in “let’s just put a spare battery in so my phone is at 100% again and I can continue doing whatever” (like with cameras for example)
Replaceable as in “my phone only lasts 2 hours instead of a day because after 3 years the battery has degraded, time to replace it with a new one”
Needing disassembly or not, at least colloquially
with standard tools (not proprietary)🥳
Goodbye tri-wing (and pentalobe) screws.
Steam deck already supports this
Phones used to have replaceable batteries until they didn’t. And they still won’t in the next couple of years, until the law is in effect.
Game consoles could go the same way, but this law can prevent it.deleted by creator
The requirement is simply that the battery is removable with commercially available tools, or if specialized tools are needed to have them provided with the product. So the SD would already be compliant.
As much as I like my Steam Deck, replacing the battery is not as easy or clean as it should be because of the glue.
Yes I know there’s a reason they glued it, and yes its good that it is “user replaceable” to some extent, but I hope this pushes for easier replacement in the future.
I would imagine that the battery cell manufacturers also play a role here, although I have absolutely no way to back this up so take it with a grain of salt. Because 99% of consumer mobile devices have glued in batteries, it is likely that Li-ion manufacturers have adjusted their supply chain to accommodate and make it less expensive for device makers to buy batteries that need to be glued. So it would be reasonable to assume if more companies need to switch to easily replaceable (read: not glued), the suppliers would shift to accommodate and stay competitive.
I mean, what is the difference behind removing the entire back with a few screws and removing a battery cover with a few screws? The Deck battery is user-replaceable. That said, I wouldn’t mind a battery compartment and for the battery not to be held down with adhesive (not sure if the Deck battery is or not, but lots of devices using flat cell batteries do).
Steam deck battery is held with adhesive unfortunately. And replacing it is difficult according to ifixit https://www.ifixit.com/Guide/Steam+Deck+Battery+Replacement/149070
I hope with this legislation it will be easier to replace.
That sucks. I replaced the batteries in my two Razer laptops recently (my 2016 was getting bloated and my 2021 battery randomly stopped charging…) and I will say it was easy enough to replace as the battery packs were held in with screws, not tape. Unscrew the screws holding the battery frame into the laptop, remove battery, insert new one, screw it down, put bottom panel back on. I don’t mind screws, just no glue or tape please. Glue and tape suck for repairability.
Yes, I think the same. Screws is way better than glue and tampe.
It’s pretty much the Achilles’ heel of the Steamdeck’s repairability.
I would rank the angry micro SD slot the Achilles heel, lol
https://youtube.com/watch?v=4T0RZ6ustKQ&feature=share8
ifixit: “Battery replacements definitely seem to be the steam deck’s achilles heel”
Easy to open yes, but still very challenging to replace the battery. Doesn’t seem to comply to the new rules to me.
I read it differently:
Further documentation stated “a portable battery shall be considered readily removable by the end-user where it can be removed from a product with the use of commercially available tools, without requiring the use of specialised tools, unless provided free of charge with the product”.
I take specialized tool to mean for example, a screw than you can’t find a driver for at a hardware store. Since all you need to replace the battery are some Phillips heads and a blow dryer or heat gun, it seems fully possible for a consumer to replace the battery using commercially available tools. Difficult sure, but should comply as-is.
IMO the law is intended to reduce consumer electronic waste, making batteries that anyone from kids to grandparents can easily replace themselves. Currently the steam deck battery isn’t all that difficult to replace for the tech savvy “brave” folks who happily open up their devices and see the internals, but for most people that’s not good enough. I would never expect my 68 year old mother to replace it herself. IMO the aim is to make batteries replaceable like the PS5 SSD expansion capacity is. Just need a screwdriver and a few minutes, without every feeling like you might break something. Needing anything more than that and most people won’t do it out of fear they’ll break their device.
But only time will tell what actually happens.
Here is an alternative Piped link(s): https://piped.video/watch?v=4T0RZ6ustKQ&feature=share8
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I’m open-source, check me out at GitHub.
Valve has switched the adhesive they use on the battery since launch. > “We have rolled in a change to the geometry of the adhesive, making the battery easier to loosen,” says Yang. Hopefully, that new shape should make it easier to pry. Source
Honestly it is so dystopian that we even have to have laws to require this kind of thing. It only makes sense to be able to replace failed parts instead of throwing out entire units or being required to have the manufacturer handle it.
In reality what happens is that devices with difficult or impossible to replace batteries end up getting thrown in the trash more often than anyone does anything else with them.
Add a counterpoint though, hasn’t the market pretty clearly indicated that this isn’t actually prioritized in a meaningful way, at least over other features, such as form factor or weight (likely the two features most impacted by more easily replaceable batteries). Other than the screen, the battery tends to be the largest and heaviest component of a handheld, so designing it to be swappable isn’t negligible.
Repairable doesn’t necessarily mean swapping though. Manufacturers make it artificially complex to repair batteries to boost sales, just because the market moved this way doesn’t mean thats what people want. I agree swapping might require tradeoffs a lot of people wouldn’t want, but there’s small changes that could help it be a reasonable fix with common tools.
Yeah I guess swap and replace are kinda getting conflated in this discussion.
With that in mind, isn’t this kinda how things are currently? Not sure what services are offered by Samsung and other Android manufacturers, but you can get an iPhone battery renewed with OEM parts by the manufacturer for about $80, which really isn’t that bad if it’s the only thing wrong with your phone.
I think people get really hung up on batteries but IMO the real issue is screens. I’ll bet way more phones wind up in “they trash” due to cracked screens than exhausted batteries.
Well you still have to go through the manufacturer and/or you need special tools, you’ll also get “genuine battery” warnings even with an original battery if you go third party or DIY. Ideally it should be thought through to be accessible for users to do themselves. And as you say, batteries aren’t the only or biggest offender.
Oh god, my heart skipped a beat because I thought they meant like AA batteries or something, whew
what’s wrong with AA batteries tho? easily swappable, hot spares, rechargable, interchangable with other devices
Only 1.5 volts.
Steam deck would need 10 AA
Let’s use 18650 batteries
Well, aside from being super chunky, these batteries have exposed terminals and can deliver massive current, and can catch fire when shorted. That’s why they’re typically not sold directly to consumers.
Or an external Powerpack, like the GameGear had 😵💫
It seems to me the steam deck already meets this regulation, or would with very minimal change. It does not say you need to have an access door like gamboys had. It just says the battery needs to be easily replaceable with commonly available tools (or included tools). To replace the steam decks battery you just need a size 0 Phillips screwdriver and something to pop it open like a guitar pick or a credit card. You would easily be able to get all the tools you need at any hardware store.
My understanding is the adhesive is quite strong. It’s also pretty nerve wracking having to take what is ultimately a sharpish instrument and poke around on something which can be extremely dangerous if punctured.
If that’s acceptable per this legislation, a lot of other products are already complaint as well. But I really, really hope this at least gets us something like screws instead of adhesive.
As I recall, valve said that they wanted the battery to be more easily replaceable. The issue was that the battery expands and shrinks during use, and they couldn’t find a good way to secure it that both kept it easily replaceable and kept it from sliding around during use. Ultimately, they had to use glue to hold the battery in place.
You can work around that, there’s plenty of designs that allow for slight thermal expansion while not using adhesive to hold down the battery. Take for example, old MacBook Air batteries, that had the cells with room for expansion but framed in hard plastic that screwed into the housing, allowing for quick and easily swapping the batteries.
Yeah, my understanding is that it’s not an insurmountable issue, it’s just one that the steam deck hardware team wasn’t able to solve in a cost effective way.
That I can believe. Between the cost of producing cells in custom housings, and the individually minuscule but collectively considerable cost of both mounting hardware and fasteners, a piece of adhesive looks a lot better to manufacturers.
Good. But next issue is availability of batteries. I can put new batteries into my old gameboy pretty easily, will you be able to get new batteries for a random handlheld in twenty years? (Something as popular as the steamdeck will probably be able.)
I wonder if Steam (and phone makers) would make the change a universal one so that people like me who live outside of EU can enjoy the same benefits too. Good job EU.
